Wiring harnes swap for CIS-E3 (or other)

[Derek L]

Ben,

>I plan to swap the CIS-E harness out for the CIS-E3
> Any tips?

I wanted CIS-E3 in my old 4000 but sold it before collecting all the pieces.
Here's a drawing I made of the 4k/5k fusebox.  It may help when you're
upside down under there making connections.

http://www.digitalnoise.org/4ktq/4/fusebox-map.jpg

>MC-1/MAC-11 turbo conversion swaps are also relevant
>I plan to install an MC-1 with MAC-11 ECU into an '83 Ur Quattro soon

I tried to document my MC1 4kq installation, it's avaliable here:
http://www.digitalnoise.org/4ktq/

A few months ago I wired a KH & MAC-07 into an '83 Urq without much
difficulty.  Yeah, the old fusebox is brittle and obnoxious, but for the
MAC-07 there were only two or three wires that went to it.  The MAC-11 has
about a half dozen connections but only a couple really need to interface
with the fuse box.  Mainly FPR ground and the fault light circut.

HTH
-Derek
4000tq - Rabbit 2.0