replacing 4kq rear tie rods

[George Nimmer]

--
--
[ Picked text/plain from multipart/alternative ]
Ok, so now I'm replacing the rear tie rods on the '84 4kq.  They are
rusted beyond recognition (and not aligned correctly), and I have the
new parts now.

My question to the group is about the attachment point on the body of
the car.  There is a small "locking tab" which blocks one side of the
bolt.  This prevents a socket from fitting over it.

What is the proper procedure for removing this bolt?  Do I just try to
pry and bend this tab out of the way?  I checked the Bentley but it
wasn't much help.

Also, once the new tie rods are on, what's the best way to prevent them
from rusting to hell?  I've heard a few things but don't know what to
believe.  One suggestion I received was to cover them with krylon brand
spray paint.  Another was to use axle grease all over them.  Any
suggestions?

TIA!!

--
George Nimmer <george164(at)earthlink.net>
--
Content-Description: This is a digitally signed message part

[ signature.asc of type application/pgp-signature deleted ]
--