Nippondenso gasket kit from acsource.com

Konstantin Bogach kbogach at comcast.net
Fri May 2 01:30:18 EDT 2003


Big o-rings from the set I got are bigger then original ones and do not fit into the groove.  ID is bigger by the
width of the o-ring.  I can push it into the groove and it will stay there pressing against outer wall of the
groove in slightly compressed state.  I think it is not good.  I found already needed size in McMaster.  Not in
stock, unfortunately.  2 days delivery means after weekend.  :-(

Thanks.
Konstantin.

James at ringsperformance.com wrote:

> I used a K20-2102 ($11.30 "gasket set, nippondenso 10p17") and a 440-398 ($16.50, "shaft seal -denso & chry")
>
> Don't forget to get the four o-rings for under the manifold (four allen bolts).
>
> ----- Original Message -----
> From: "Konstantin Bogach" <kbogach at comcast.net>
> To: <quattro at audifans.com>
> Sent: Wednesday, April 30, 2003 11:10 AM
> Subject: Nippondenso gasket kit from acsource.com
>
> > Hi.
> > I bought the kit from acsource for Nippondenso 10P17C (200tqa '89) and
> > the kit they sent me (K20-2102) does not fit:  big O-rings are too
> > large.  There web site states that this kit is for 10P17.   Do 10P17 and
> > 10P17C have different sizes?
> > Did anyone resealed compressor from 200tq?  What kind of compressor it
> > was?  Where did you get gasket kit?
> > Sick day started so nice (flushed condensor, cleaned/washed compressor
> > inwards) and ... usual thing happend - either no tool or part has wrong
> > size.  D-a-m-n!  Now I will have clean house :-(
> >
> > Konstantin.
> >
> >




More information about the quattro mailing list