Nippondenso gasket kit from acsource.com

[Konstantin Bogach]

After calling several places who use the same o-rings (from the same
supplier as acsource) I'd like to get back my statement that they are too
big.  I still have doubts whether I should use them but rebuilders claim
that they are using them.
I ordered o-rings from McMaster (neoprene, ID 4''1/2, W 3/32) and after I
receive them I will decide what to use.
But I always thought that new o-ring should rest in groove without any
stretching or compression.

Regards,
Konstantin.

Konstantin Bogach wrote:

> Hi.
> I bought the kit from acsource for Nippondenso 10P17C (200tqa '89) and
> the kit they sent me (K20-2102) does not fit:  big O-rings are too
> large.  There web site states that this kit is for 10P17.   Do 10P17 and
> 10P17C have different sizes?
> Did anyone resealed compressor from 200tq?  What kind of compressor it
> was?  Where did you get gasket kit?
> Sick day started so nice (flushed condensor, cleaned/washed compressor
> inwards) and ... usual thing happend - either no tool or part has wrong
> size.  D-a-m-n!  Now I will have clean house :-(
>
> Konstantin.