pressing in A/C clutch bearing-howto?
Konstantin Bogach
konstantin.bogach at morganstanley.com
Tue May 6 12:49:07 EDT 2003
I am going to press in new bearing and the quesiton is where to apply
pressure - inner or outer race. They are not in the same plane, inner
race in wider. It is hard to find metal bushing-driver I can use on
the outer race - it should have very specific ID and OD. I actulally
destroyed old bearing and was going to use outer race as driving bushing
but... the bearing sits and inch below the clutch surface and if I drive
the new bearing all the way down I will not be able to remove "driving
tool". It leaves me with only option to presson inner race. I am
afraid it will damage the bearing. Or not?
Thanks for you input.
Konstantin.
More information about the quattro
mailing list