FW: 5kTQw vibration under load

Dan Cordon cord4530 at uidaho.edu
Wed May 21 19:18:04 EDT 2003


Thanks Stephane-

I'll give that a try next time I'm wrenching on the audi. Though, when I
do the 20V swap I'll lose that capability :o(

--
Dan Cordon
Mechanical Engineer - Engine Research Facility
University of Idaho

> > What I'm wondering is if it's possible to remove the rear driveshaft
> > (propellor shaft) and drive the car with the center diff locked.
>
> Yes, you can definitely do this.  I did when I was trying to isolate a nasty
> vibration/humming noise.  turned out to be a rear wheel bearing, but I had
> taken the propshaft out and driven front wheel drive only.
>
> Stephane
>




More information about the quattro mailing list