KV engine setup

[Mihnea Cotet]

The KV engine is a basic CIS with vacuum advance, the correct specs
according to the factory repair manual are 18 degree BTDC with vacuum
disconnected, CO should be 1 +/- 0.2% at idle. This engine has no cat.

HTH,

Mihnea

At 15:23 30/09/2003 -0400, JShadzi at aol.com wrote:
>--
>[ Picked text/plain from multipart/alternative ]
>Phil, is that the basic CISE system with vacuum advance distributor?  If so,
>close off vacuum signal to dist and set base timing to 6d BTDC, reconnect
>vacuum signal, also ensure that the vacuum advance cannister is not
>leaking, which
>it likely is.
>
>Javad
>
>In a message dated 9/30/2003 11:59:43 AM Pacific Standard Time,
>quattro at isham-research.com writes:
>Anyone know the official way to set up the timing on a KV?
>
>--
>   Phil Payne
>   http://www.isham-research.com
>   +44 7785 302 803
>   +49 173 6242039