turn signal question

[Ron Wainwright]

  This happened to me while replacing the rack on my
200,
 the problem was the rack wasn't centered.
 Theres a bolt & nut holding the steering housing at
the firewall you have to make sure the nut & bolt are
facing down not on the side or upside down (know what
I mean?) If you are in the driver side & looking at
the end of the steering shaft the nut & bolt should be
at the bottom of the shaft. There should be 3 1/2
turns to center on each side.
 & as Huw mentioned you have to push the housing &
steering shaft tight. If you can push the wheel down
from the driver seat than you need to retighten the
nut & bolt. 
 Hope this helps.
Thanks
Ron
87 5ksq many mods
90 200tqa many mods
90 V8 pearl 89k 02 S4 17's Urs4 sport seats, stebro
exhaust, "Big Reds"
90 V8 tornado red 147k


		
__________________________________
Do you Yahoo!?
New and Improved Yahoo! Mail - Send 10MB messages!
http://promotions.yahoo.com/new_mail