My 100Q has no power again,,, big cow..
Kent McLean
kentmclean at mindspring.com
Sat Dec 11 08:37:14 EST 2004
Denis wrote:
> I tried to get fault code but something i dont do or missunderstand procedure
> (in english) cause i cant get any engine light blink or not......
> The fault code procedure is: (what i have undrestood)
> turn the key on, plug a fuse on the fuel pump relay for 4 secondes , then
> i can see the engine light flshing to show me the code..... this computer should
> speak to me :-) and tell me whats wrong hehe.
On the older Audis, you need to keep the engine running when
you perform the test. Insert the fuse for 4 seconds, then
remove it. Count the flashes -- a series of flashes, a longer
pause, more flashes, another long pause, more flashes, another
long pause should give you your first code. Repeat inserting
and removing the fuse to get any remaining codes.
Scott Mockry's site gives a good write-up:
<http://www.sjmautotechnik.com/trouble_shooting/ecuf.html#fc5kt>
Go here to decipher the codes:
<http://www.sjmautotechnik.com/trouble_shooting/10vcodes.htm>
HTH,
Kent
'94 100 S Avant
'89 200 TQ, "Bad Puppy" needs a new home
More information about the quattro
mailing list