016 vs 01A flywheel pin ?? Re: Timing belt align to rotor problem.

Denis sparkplugvw at hotmail.com
Thu Dec 30 16:33:30 EST 2004


  Something to do about tranny sensors ?
  I remove the 01A tranny and using a 016 from a 5000TQ 86, ref pin ?
  Ðenis
    ----- Original Message ----- 
    From: Tony Hoffman 
    To: quattro at audifans.com 
    Sent: Thursday, December 30, 2004 3:10 PM
    Subject: Re: Timing belt align to rotor problem.


    > Maybe, the distributor shaft jumped gears or
    > something. Who the hell knows.
    > You got one weird puppy there.
    > 
    > If it was me, I would remove the distributor and
    > check it out thoroughly.
    > I dont know how to check the gearing inside the head
    > or the block. Somebody
    > else has to chime in on this.
    > I think the distrubutor end has a slot or groove
    > that mates with the slot or
    > groove inside the engine. Maybe these are rounded
    > off? The distributor end
    > is not fully engaging into the gear? Take some
    > measurements and see what you
    > have.



    If I recall, the distributor gear is held on the shaft
    with a roll pin. If that pin has broken/sheared it
    will allow the gear to spin on the end of the shaft.

    Tony Hoffman



    __________________________________ 
    Do you Yahoo!? 
    Yahoo! Mail - 250MB free storage. Do more. Manage less. 
    http://info.mail.yahoo.com/mail_250
    _______________________________________________
    quattro mailing list
    quattro at audifans.com
    http://www.audifans.com/mailman/listinfo/quattro



More information about the quattro mailing list