re. 100Q finally started:bad distributor plate.

Denis sparkplugvw at hotmail.com
Tue Feb 3 10:52:18 EST 2004


Ok i see.

Ok ll check the PP and flywheel before do anything. 

If it s ok ,,,mmmm, i really dont know why it s not engaging... before the swap every thing was ok.

5000TQ engine with his tranny..... then swapped the tranny to the 2.3 engine on my 100Q 1989, with the clutch, PP and flywheel from the 5000TQ. Only the engine is different from the old setup.

So why ( i m asking to myself) it did not want to engage,, and slip alot...  grease on it ? wrong side clutch !!! it cant be. , new realease bearing new needle bearing... new disk... my friend told me only make it slip to make the surface identical, then the clutch ll engage. It s not suppose to take more than a minute to  do so....

Maybe i must use the master clutch cylinder from the 5000TQ and put it in the 100Q . Master cyl swap.... maybe the clutch cyl. stay a little engage,,  was perferct there too  before swap...


Denis

Denis
  ----- Original Message ----- 
  From: Ben Swann 
  To: Denis ; quattro list 
  Sent: Tuesday, February 03, 2004 10:43 AM
  Subject: Re: re. 100Q finally started:bad distributor plate.


  I apologize for the lack of snippage when I replied to this post earlier.  I didn't realize Q'list was in copy until I got the archive.
   
  Ben
    ----- Original Message ----- 
    From: Denis 
    To: quattro list ; Ben Swann 
    Sent: Tuesday, February 03, 2004 8:00 AM
    Subject: Re: re. 100Q finally started:bad distributor plate.


More information about the quattro mailing list