Cam/Crank shaft oit seal removal 90q 20v

[SJ]

> From: David Thoresen <david at epicfoto.com>
>
> So far I broke 2 tips off of random knives, tried the screw technique
> (screw pulled right out..), tried to stick a screw driver in there...
> nothin...
**** This is how I got the seal out.
Get two screws with very wide flutes/threads. I think I used some kind of
sheet rock screws, or screws used for particle board . . . thin shank but
huge threads. The bigger the thread, the better the grip.
Drill 2 small holes 180 degrees apart.
Carefully screw in the 2 screws.
Using pliers and a block of wood for a fulcrum, grab a screw and very slowly
lever out each side just a little at a time. If you do one side too much,
the seal will cock and jam.

SJ