How to replace Front Wheel Bearings?

[Ado Sigal]

>
>
>  why does the Bentley and Haynes indicate
>that Locktite be used on the CV joint splines before you assemble and torque
>things down?
>What function does the Locktite perform? If anything, it is the bolt that
>should get the locktite and not the spline.
>Maybe its to eliminate any side to side play between the drive shaft spline
>and the hub?
>What would be the result of that that kind of play?
>
>SJ
>
Loctite is there mainly to prevent the moisture getting through and 
rusting the shaft splines and bearings. Using a compound that doesn't 
set hard is sufficient, and very much easier to remove next time.

The shaft nut is self locking, as well as all other suspension related 
nuts, and needs no other compound applied.

Regards,

Ado