How to replace Front Wheel Bearings?

cobram at juno.com cobram at juno.com
Wed Jun 23 12:09:00 EDT 2004


Clean up the front and rear of the bearing hub with some brake or carb
cleaner, a wire brush helps too.  Will make it easier to see whether
there is a circlips in there or not.  If you are using a tool like the
"Hub Shark" (look in the archives), you really should be using an air gun
on the bolt.  Those bearings are in there TIGHT.  

BCNU,
http://www.geocities.com/cobramsri/

 SJ <syljay at optonline.net> writes:

> I ran into a problem regarding the front bearing replacement on my 90 
> 100q.
> I cannot press out the bearing. So far, I have not tried too hard in 
> turning the tool bolt. I want to make sure I dont break something.


More information about the quattro mailing list