How to replace Front Wheel Bearings?

Livolsi, Stephane Stephane.Livolsi at investorsgroup.com
Wed Jun 23 14:33:07 EDT 2004


Just adding my .02, the list chatter about home built and purchased
bearing pullers inspired Tihol and I to build our own and we got a bunch
of steel tubes and plates from the scrap yard.  Tried to pull the
bearing out of my 88 5ktqa and no-go, it just bent the steel plate we
used for backing.  It was well over 1/4" thick steel.  Ended up swapping
a strut in from the parted out 5ktq sedan. One of these days I will take
the avant strut to the shop and get the new bearing put in and reinstall
it on the car, but it just isn't a priority right now.




More information about the quattro mailing list