272 cam install...

[Alan Pritchard]

>your computer will automatically adjust if you are a little of. if you were

a lot off, it wouldn't have ran as well as it did. as for the cut out.... 
you may want to think about chipping your computer. It isn't mapped to 
supply gas at such a fine rate as the 272 necessitates. and if you go that 
route there a few places that do good jobs with chipping your ecu - 2 
Bennett, TAP, and intended acceleration (I prefer 2Bennett) talk to andrew 
bennet tell him jesper sent you.
other wise... good luck!<

not too much of a worry, as I am currently getting my megasquirt setup
prepared for installation.....
thanks anyway!!!



Best Regards,
Alan Pritchard

Network Administrator
Mechanical Design Engineer
Seaeye Marine Ltd.
+44 (0)1329 289000