electrical connector sourcing question

[Alan Pritchard]

Hi guys, progressing on with my megasquirt'n'spark coversion on my '90 90q
10v.
Starting on the loom right now. I want to try and make an interface cable
that splices into the existing loom, ie so I can connect onto the original
loom at the ignition and fuel ecu, I figure its easier to do this and have a
reversible process, most of the connections I need are present at these
ecus. For example
Permanent 12v, switched 12v, ground, coolant sensor, tach input, spark
output. By doing this it will save me a lot off hassle getting behind the
fuse box etc, and also allow me to perform a modular installation, while
keeping the board computer happy by keeping its feeds intact, also it will
mean I can run spark first, then easily switch to fuel. If I fit a suitable
switch I should also be able to switch between the original ignition
computer and the ms'n's box. So my question is this, does anyone know the
part number, or source of the required connectors, ie the male and female
mating parts of the ignition ecu and fuel ecu. Or even just the manufacturer
and number of pins?
Many thanks


Best Regards,
Alan Pritchard

Network Administrator
Mechanical Design Engineer
Seaeye Marine Ltd.
+44 (0)1329 289000