Wheel Stud Conversions

[Steve R]

I never quite finished with my stud plan, but then again my URQ isn't
finished either. Being an old time Porsche person, I had planned on using
Porsche wheel studs which are available in many lengths. For the nuts, again
I was using Porsche. They have to be reshaped of course to fit the Audi
shape which I lathe cut using an optical comparator to check the shape as I
was cutting.

Steve

----- Original Message ----- 
From: "Larry C Leung" <l.leung at juno.com>
To: <s-car-list at audifans.com>
Cc: <quattro at audifans.com>
Sent: Saturday, October 02, 2004 7:39 PM
Subject: Wheel Stud Conversions


> Hello Listers,
>
> Looking for anyone whom has recently converted to studs
> on their turbo (14 x 1.5 mm pitch?) Audis? Looking for info
> on:
>
> Vendor
>
> Cost
>
> Availible nut type (cap or open, chrome or standard finish,
>                                 ball or cone seat, lock or hex)
>
> How did you select stud length?
>
> You can reply on or off list.
>
> Thanks,
>
> LL - NY
> _______________________________________________
> quattro mailing list
> quattro at audifans.com
> http://www.audifans.com/mailman/listinfo/quattro
>
>