[Fwd: Re: valve spring height spec for 10V is sought]

[Konstantin Bogach]

-------- Original Message --------
Subject: 	Re: valve spring height spec for 10V is sought
Date: 	Mon, 18 Oct 2004 11:12:18 -0400
From: 	Konstantin Bogach <konstantin.bogach at morganstanley.com>
To: 	a.sigal at bluewin.ch, quatttro at audifans.com
References: 	<416FF4E6.5070005 at morganstanley.com> 
<41709FD9.8030705 at bluewin.ch>



Ado Sigal wrote:

> Konstantin Bogach wrote:
>
>> Does this info available in Bentely?  I did not find it in Chap. 15 
>> (Head).   I would appreciate if you let me know min acceptable height?
>>
>> Thank you.
>> Konstantin.
>>
>> _______________________________________________
>> quattro mailing list
>> quattro at audifans.com
>> http://www.audifans.com/mailman/listinfo/quattro
>>
> Konstantin,
>
> Somehow 2 mm difference comes to mind (someone will come with right 
> length I'm sure), but what is routinely done, is to lay the springs in 
> line next to each other in their respective positions (inner and 
> outer), and put the metal ruler on the top. Since is unlikely that all 
> the springs are out, any discrepancy in length would show then.
>
> Regards,
>
> Ado
>
>
>
Ado,  thanks for response.  Smaller springs have length varying from 
34mm to 35mm.  Larger springs are all close to 40mm long.   I can not 
find the spec anywhere.  Folks in dealership could not help either - 
could not locate a paper of book with the info.

Folks,   maybe someone has new or, at least, fresh set of stock springs 
laying around.  I would appreciate if you mesure one or two springs 
each  -  smaller and larger ones,  and let me know the lenghts.

Thank you.
Konstantin.