Clutch R & R--Type 44, '90 200 QT Avant, HELP.

[Pat Korach]

Phil

Make sure you mark the position of the center bearing bolts of the drive
line.  So when reinstalling it, it  is still centered.  I used spray paint
and also make sure the tranny and engine mount bolts are in the same
location too.  If not your drive line may vibrate if not centered.

Pat Korach
Kirkland, WA.
----- Original Message -----
From: "Phil Haag" <philhaag at hotmail.com>
To: <quattro at audifans.com>
Sent: Saturday, September 11, 2004 9:03 AM
Subject: Clutch R & R--Type 44, '90 200 QT Avant, HELP.


> Lister's Help....
>
> I am doing a clutch this weekend... I remember that about a month or so
ago
> there was a thread on clutch installation issues. I thought I had saved
it,
> though cannot locate it now. Please any advice would be appreciated. This
is
> my first Audi clutch.
>
> I will also be doing the driver's side wheel bearing. I had some info on
> that as well but cannot locate it. Yeah, I know I could lose my head and
not
> know... Well any references would help. Like how to maintain alignment
when
> taking down the strut etc.
>
> Thanks,
>
> Phil Haag
>
> '90 200 Quattro Avant
> 220,000 miles (yes, time for a clutch)
> 1.9 Bar
>
>
> _______________________________________________
> quattro mailing list
> quattro at audifans.com
> http://www.audifans.com/mailman/listinfo/quattro
>
>