Clutch R & R--Type 44, '90 200 QT Avant, HELP.
Phil Haag
philhaag at hotmail.com
Fri Sep 17 21:30:14 EDT 2004
Pat,
Thanks for the tip. I marked the bolts / bracket location.
Phil
>From: "Pat Korach" <tm2 at zipcon.net>
>To: "Phil Haag" <philhaag at hotmail.com>,<quattro at audifans.com>
>Subject: Re: Clutch R & R--Type 44, '90 200 QT Avant, HELP.
>Date: Sat, 11 Sep 2004 10:08:00 -0700
>
>Phil
>
>Make sure you mark the position of the center bearing bolts of the drive
>line. So when reinstalling it, it is still centered. I used spray paint
>and also make sure the tranny and engine mount bolts are in the same
>location too. If not your drive line may vibrate if not centered.
>
>Pat Korach
>Kirkland, WA.
>----- Original Message -----
>From: "Phil Haag" <philhaag at hotmail.com>
>To: <quattro at audifans.com>
>Sent: Saturday, September 11, 2004 9:03 AM
>Subject: Clutch R & R--Type 44, '90 200 QT Avant, HELP.
>
>
> > Lister's Help....
> >
> > I am doing a clutch this weekend... I remember that about a month or so
>ago
> > there was a thread on clutch installation issues. I thought I had saved
>it,
> > though cannot locate it now. Please any advice would be appreciated.
>This
>is
> > my first Audi clutch.
> >
> > I will also be doing the driver's side wheel bearing. I had some info on
> > that as well but cannot locate it. Yeah, I know I could lose my head and
>not
> > know... Well any references would help. Like how to maintain alignment
>when
> > taking down the strut etc.
> >
> > Thanks,
> >
> > Phil Haag
> >
> > '90 200 Quattro Avant
> > 220,000 miles (yes, time for a clutch)
> > 1.9 Bar
> >
> >
> > _______________________________________________
> > quattro mailing list
> > quattro at audifans.com
> > http://www.audifans.com/mailman/listinfo/quattro
> >
> >
>
>
More information about the quattro
mailing list