WGVF urS4

[Robert Rossato]

> Well after having a play tonight, i ran the ecu output tests 
> all checked out fine and cleared any codes as per sjm's site. 
> then i measured the distance down the wastegate to top of the 
> screw having read on an S2 that the stock distance should be 
> around 2.54cm, came up short on that one so screwed it down 
> to just over 2cm, bingo right on the money, car drives like 
> scalded cat saw nearly 2.9 bar with a little hesitation at 
> full load so dialled the screw back a touch.
> 
> I would be interested to know how far down the wastegate 
> everyone elses screws are?????

>From the factory there is a cover over the wastegate screw to prevent
adjustments, so unless the cover is removed there is no way of knowing.
Obviously a previous owner drilled through the cover to gain access and
botched up the settings.  I hadn't heard before what the factory setting
should be or what their adjustment criteria was, i.e. spring force or
distance of screw from some surface, but that's interesting to note.  If
I ever drill out the cover on mine I'll have to put a depth gauge to it.
I do recall that Hoppen used to say to turn down the screw 6 turns when
installing the MTM +1 chip.

Bob