rear differential mount-using VW engine mount?

Aaron Jongbloedt jungle at hickorytech.net
Thu Feb 17 16:30:25 EST 2005


I tried this, i can't remember which mount i purchased but it didn't work.  The
one i tried the hole wasn't off center and it was softer than the one in the
tranny w/ 200k on it.  I have found that German Auto Parts can get the audi 4000
bushing, which i THINK is the same one as for our cars.  I also know that there
are some derlin poly busings available aswell.

TWFAUST at aol.com wrote:

> On advice from another list, I purchased a VW engine mount bushing to replace
> the rear, rear differential mount bushing on my '91 90Q sedan. I notice the
> center bolt hole of the bushing is slightly eccentric (off center). What
> position should the bushing be placed in relative to the center mount hole?
>
> Tom Faust
>
>
> _______________________________________________
> quattro mailing list
> quattro at audifans.com
> http://www.audifans.com/mailman/listinfo/quattro

--
aaron...
------
Aaron J. Jongbloedt
 "youngblood"
Sabis Educational Systems Network Administrator
----------------------------------------------------
    work email: ajongbloedt at sabis.net
personal email: jungle at hickorytech.net
      work url: http://www.ism-sabis.net
      work url: http://www.sabis.net
  personal url: http://blacksunshine.freeservers.com
 msn messenger: jungle001 at hotmail.com
----------------------------------------------------
It is better to wear out than it is to rust out.




More information about the quattro mailing list