4k fuel lines

[TWFAUST at aol.com]

What is so wrong with the idea of simply using the existing terminals and 
running high pressure rubber hose?  Since the hose is fairly expensive, how about 
steel tube? Brake line should do and then just connect it with hose to each 
terminal end. I a hand held tubing bender is only about $15.00. It might be an 
excess of caution but buy a couple of unions, disassemble them and solder a 
ferrule on each end of the new tube. That would provide an even greater seal at 
the hose connections. Perhaps just unions between the terminals and the new 
tube. My home water pressure is about the same as Audi fuel pressure and I have 
never had a union leak, not even the ones that hold in the pressure reducing 
valve I had installed.

Tom Faust