Check Engine Light
Denis
sparkplugvw at hotmail.com
Thu Jan 27 12:37:06 EST 2005
The dealer ? the dealer its me :-). I fix almost everything.
I found the coolant sensor defect and the idle / full trottle connector oxided.
i pulled the code with the 100Q 89 wiring, with 2 connectors, the brown and the black one.
Ðenis
Form Doug Yoder
/--\ +--\
|A1| |B1|
| | | |
|A2| |B2|
+--+ +--/
Connector A is listed as "dark" and B is supposed to be "light". B1 is
not connected to anything in the wiring harness.
Put the LED + resistor between A1 and B2. Then put a wire with
push-button switch between A2 and B2. Activating the switch is the same
as putting a fuse in the top of the fuel pump relay. IE, push the
switch for 4 seconds, and the LED starts blinking the fault codes.
Good luck!
-Doug Yoder
----- Original Message -----
From: Phil Payne
To: quattro at audifans.com
Sent: Thursday, January 27, 2005 6:55 AM
Subject: Re: Check Engine Light
If you don't have a blue connector, how has your dealer been pulling the
codes?
_______________________________________________
quattro mailing list
quattro at audifans.com
http://www.audifans.com/mailman/listinfo/quattro
More information about the quattro
mailing list