dead gauges resolution 89 90Q

[Huw Powell]

So, I had traced the four dead gauges to fuse #12 blowing.  Tracked the 
other circuits, found problems on the back up light circuit.  Unplugged 
switch at tranny to drive until I had time to dig in.

Today, I tested the circuit, the switch is ok, and the lights could be 
made intermittent by wiggling the harness by the drivers side trunk 
hinge.  (did this with a circuit breaker wired into my fuse breakout 
thingie)

Sliced the bundle open, and all seven wires were bare for about 1/8". 
Removed about 8" of each, soldered and shrink wrapped in replacement 
bits of wire, all is well now...

-- 
Huw Powell

http://www.humanspeakers.com/audi

http://www.humanthoughts.org/