Fuel Injector 'Doughnut' installation...

Jan Pinkowish jpinkowish at earthlink.net
Sun Oct 23 14:23:32 EDT 2005



-----Original Message-----

Message: 1
Date: Sun, 23 Oct 2005 08:25:54 -0700
From: "orsopers" <orsopers at comcast.net>
Subject: Fuel Injector 'Doughnut' installation

I am currently replacing the injector sleeves and o-rings on my '88 80q (NG
motor)  and I remember reading here once that you could use very hot water
to soften up the really tight green 'doughnut' o-rings that go on the top of
the injector.  Is that true?  The Bentleys says to lubricate before
installation but that is all.

Rand Soper
'88 80q


<><><><>
Rand,
--Soak the green doughnut seals in gasoline for a few minutes.
--Cut a tapered plastic nozzle from the end of a tube of caulking(silicone, bathroom, etc.) so that its widest end will fit over the cap(non threaded) end of the injector.
--insert the injector into the plastic nozzle and slide the green seal up the nozzle and onto the injector.  This takes a try or two, but works fine.
--slide the green seal into place on the injector.

HTH

Jan Pinkowish
'85 4ksq



More information about the quattro mailing list