Ignition Switch Removal Question 90q

Kent McLean kentmclean at mindspring.com
Thu Apr 6 17:07:21 EDT 2006


On Thursday 06 April 2006 15:28, David Thoresen wrote:
> I have the cluster off the dash, does the ignition
> switch just need to be pulled out or is there
> something else  holding it in?

If the 90q is like my 100, the switch is in two parts -- a
key half and electrical half. The key half usually stays
put when your replace the electrial half, which is what
fails.  

There should be 2 set screws imbedded in the top of the
combo. (Use a small mirror to see them.) The are covered
with red paint.  The screws take a small straight-blade
screw driver (about 1/8-inch or 2mm or so). I put a drop
of paint thinner in the recess to loosen the paint, 

IIRC, you don't need to remove the screws, just loosen
them a bit (1-2 full turns).

Having written all that, I remembered this:
http://www.audifans.com/twiki/bin/view/Audi/IgnitionSwitchReplacementC4

And this for the urQ may help:
http://www.audifans.com/twiki/bin/view/Audi/IgnitionSwitchRemoval

-- 
Kent McLean
'94 100 S Avant, "Moody"
'89 200 TQ, "Bad Puppy" up in smoke


More information about the quattro mailing list