Exhaust flange - Engineering Design Challenge for you Audifans tinkerers

[cobram at juno.com]

I don't think the muffler shop wanted the job, find another one.  From
what I understand from your post,  any muffler shop with a pipe bender
should be able to put a flare on the pipe itself and fit a universal
(multi- hole) flange to press it and hold it against the donut.  Worse
case just put a reduction adapter in there and weld the pipe to the cat.

BCNU,
http://www.geocities.com/cobramsri/
Health is merely the slowest possible rate at which one can die.
 
SJ <syljay at optonline.net> writes:
> I have a problem.
> My 88 5kq, non turbo needs a 4 hole mounting flange on the end of 
> the
> downpipe for connecting the downpipe to the Cat. The flange needs an 
> inside
> bevel to match the flared donut that sits between flange and cat.
> 
> No FLAPS has this type of flange. The local Meineke shop had nothing 
> to
> match.
> A 4 hole flange in stainless would be nice, but I'll settle for 
> anything
> right now.
> I need to come up with a solution and you all can help out.