Clutch Job : Input S won't go thru pilot b-any tricks?

L DC ldc007usa at yahoo.com
Mon Aug 28 10:52:54 EDT 2006


Thanks Kneale!!

And, yes, I sure did tried and fit nicely, the pilot
bearing at the end of the input shaft. It even felt it
was just a tad oversize to compensate for its slight
compression while in the rear crank shaft.

LDC

--- Kneale Brownson <kneale at coslink.net> wrote:

> Did you check the fit of the pilot bearing over the
> tranny input shaft?  
> 
> 
> At 06:48 AM 8/28/2006 -0700, L DC wrote:
> >Hi everyone.
> >
> >Sunday, I tried and tried to make the tranny's
> input
> >shaft in my '85 VW QSW go through the pilot bearing
> >but was unsuccessful. 
> 
> 


__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com 


More information about the quattro mailing list