80q oil psi gauge sender

[Jim Dupree]

Matt,
If you are adding a gauge to your 80q you need a gauge
sending unit. Most Audi's without a factory gauge only
have oil pressure switches in the block. The gauge
sending units are about 1.5 inches in diameter and a
couple inches tall with 2 electrical connector on
them. 1 for the pressure switch and 1 for the gauge.
If you only have switches you can replace one of the
switches with the appropriate sending unit.
I might even have a sending unit out in my garage.
Good Luck
Jim

--- Matthew Kramer <stpndsmn at yahoo.com> wrote:

> Thanks to all who responded!
>    
>   Sounds like everyone is saying that the sensor is
> the one that mounts in the side of the block...   My
> 4kq already has two sensors mounted in the radiator
> side of the block..  Can I just use the one that is
> there??
>    
>   Thanks
>   Matt
> 
> 		
> ---------------------------------
> Relax. Yahoo! Mail virus scanning helps detect nasty
> viruses!
> _______________________________________________
> quattro mailing list
> quattro at audifans.com
> http://www.audifans.com/mailman/listinfo/quattro
>