MC engine swaps question

[Jim Dupree]

I'm no expert on the MC swap into a 4kq but my understanding is that the
flywheel and press plate from the MC eng fit the 4kq trans. The MC will need
the original flywheel because of the timing pins.
There are several people on the list that have done this swap and a few web
pages that have good info.
Good luck
Jim
----- Original Message ----- 
From: "Daniel Stevens" <dosteven at syr.edu>
To: <quattro at audifans.com>
Sent: Wednesday, February 15, 2006 12:14 PM
Subject: MC engine swaps question


>
>
> OK as i'm looking into and learning what i'd need to know just to ask
questions about doing an 5cyl engine swap..
>
> What about the Flywheel and sensor?  are there sensors relating to the
flywheel?
>
> Engine knock?
> timing?
> tach?
>
> it's my understanding the 4000q 5cyl uses a 228mm clutch and PP
> does the 5000 turbo flywheel fit in the 4000q bellhousing?
> I guess i'm not sure what the clutch diam and consequently PP diam of the
5000T is.
>
> sop the golden question is
> would a 4000q (5cyl, 228mm) flywheel work with the IGN and ECU of the
5000turbo?
>
>
> Thanks for your time and consideration.
>
> Dan Stevens
> 1987 5000CS quattro
> 1987 syncro camper
>
> _______________________________________________
> quattro mailing list
> quattro at audifans.com
> http://www.audifans.com/mailman/listinfo/quattro
>