Need help, anyone with a CIS degree and familiar with Audi ignition systems

[Matthew Kramer]

Hi,
   
  I am finishing up my 4ktq project and got it running  (sort-of)  tonight..  I have an 85 4kq and did a temporary low boost conversion until I can get EFI.  So I have a turbo engine with 4kq CIS etc...   In order to make it all fit I turned the CIS unit around so the throttle plate is in the front.  I am assuming that the fuel hoses do not need to be connected to the CIS head in any particular order of sequence save for the Cold start injector.  I have no idea which line goes where and it is all connected now.  
   
  Also the ignition on my car was the type that had the post style terminals in distributor and coil instead of being hollow with the contact around the outside.  I had a set of wires for the other style of terminal and a coil, cap, rotor...  so I put all of those onto my 4kq distributor and everything seemed to fit fine.  I guess I just need to know If I can actually do that and expect it to run or if I need to get a set of wires and a cap/rotor that all have the post style terminals....
   
  The car fired up but didn't run very well possibly slightly out of time but not sure yet.
   
  any thoughts or help would be much appreciated
   
  thanks
  Matt

		
---------------------------------
Do you Yahoo!?
 With a free 1 GB, there's more in store with Yahoo! Mail.