Drive shaft parts, seat heaters

Grant Lenahan glenahan at vfemail.net
Thu Oct 26 07:58:12 EDT 2006


I believe it was a 325ix, btu maybe you;re right.
Grant
On Oct 26, 2006, at 5:02 AM, Mark J. Besso wrote:

> On my 4KQ the center support bearing was equal in every dimension to 
> one
> from a Ford F150 so the replacement was something like $16 at the 
> FLAPS.
> The rubber piece that surrounds it was pretty whooped and I seem to 
> recall
> the technician replacing it with a modified one for a BMW 528e.
>
> ~MB
>
>
> -----Original Message-----
> From: Peter Golledge
> Subject: RE: Drive shaft parts, seat heaters
>
> Cody,
>
> Yes you can remove the yoke, replace the bearing and put it back 
> together.
> BTDT.
>
> I would replace the u-joint while you are taking everything apart.
>
>> So back to the driveshaft deal. My driveshaft just needs the center
> support.
>> Can I press the center support from the rebuilt shaft and install it 
>> on
> the driveshaft
>> currently in my car if I mind the alignment of the yoke and u-joint?
>
>
>
> _______________________________________________
> quattro mailing list
> quattro at audifans.com
> http://www.audifans.com/mailman/listinfo/quattro
> ---
> Watch this space for ads :)



More information about the quattro mailing list