Megaquirt V2.2 5 cyl configuration

[Ben Swann]

Well - that is what I am trying to determine.  I have the distributor set per
Bentley and other publications - dead on.  But no pictures show how the wires
are supposed to be, that is.

What I am not sure of is which terminal the no. 1 wire should be on.
Presently it is on the one that is directly over the rotor pointing to the
line that rotor is pointing to - hash mark on the distributor that rotor is
lined up with when engine is at TDC no. 1. 

There is no question, I'm getting spark.  The question is if it is happening
at the right time.  It may be very retarded, as I think if it too advanced,
I'd be getting a back fire.

Ben

-----Original Message-----
From: Huw Powell [mailto:audi at humanspeakers.com] 
Sent: Wednesday, April 25, 2007 10:33 PM
To: Ben Swann
Cc: 'Scott Phillips'; 'Ingo Rautenberg'; quattro at audifans.com
Subject: Re: Megaquirt V2.2 5 cyl configuration


> But I do have spark - plenty good spark.  I theoretically should be able
> to start this engine for a few seconds by putting fuel or starting fluid in
-
> but no go.

No fire with ether?  And yet you have spark... I hate to sound obvious, 
but is the spark near TDC on compression?

-- 
Huw Powell

http://www.humanspeakers.com/audi

http://www.humanthoughts.org/