Help ident. an engine / KH vs. MC

Ameer Antar antar at comcast.net
Sun Jul 15 23:45:08 EDT 2007


Ya, the intake manifold shouldn't be a problem. The manifold bolt pattern is
the same. The KH has the MAT sensor in the manifold rather than the
intercooler. I'm pretty sure the oil filter housing will swap too. You need
a 32mm(?) socket to undo the KH housing. Then just use a bolt through the
oil passages of the stud to give you something to grab on to. I'm pretty
sure the bolt for the MC uses the same thread as the stud.

How the hell did you melt the block? I did the same to my pistons. I can see
that, but melting the block... that's pretty good!

-Ameer

On 7/15/07, Cody Forbes <cody at 5000tq.com> wrote:
>
>
> > The KH has hydraulic lifters, even though it has a coolant pattern
> > similar to the older solid lifter blocks. It's just as good as an MC,
> > but the  pistons are a bit smaller. Compression is about 8.3:1, so
> > it's a little better off the line.
> >
> > -Ameer
>
>
> Any clue if the intake manifold can exchange with an MC? I'm considering
> dropping the KH in my 5ktq for a short time while I build up another MC. I
> uh sorta melted a bit of the block thats currently in the car.. ;-). If I
> can bolt up an MC oil filter housing and intake I'll be set.
>
> -Cody Forbes
> http://www.5000tq.com
> '87 5ktq - Fast.
> '86 5ktqCD
> '86 5k
> '86 5k
>
>
>
>


More information about the quattro mailing list