A couple clarifications for injectors

[Al Streicher]

You may or may not need the CIS injector tool. All of my shroud/injectors
all pulled out very easily. Yours may not, they may break, so go slow and
use the tool if you need. You might put a rag around the injector you are
working on, so little pieces don't fall where they shouldn't be.

Go here for more info
http://www.sjmautotechnik.com/trouble_shooting/injector.html#inject

Huw's site great pics and info
http://www.humanspeakers.com/audi/injectors-90.htm

I had to use a Dremel to cut, lengthwise, the air shrouds off. The injector
would not pull out.
When you remove an injector assy, stuff a clean rag into the opening.

Al

-----Original Message-----
From: quattro-bounces at audifans.com
[mailto:quattro-bounces at audifans.com]On Behalf Of Dave Yentema
Sent: Wednesday, November 19, 2008 3:41 PM
To: quattro at audifans.com
Subject: A couple clarifications for injectors


well, my injector seals and air shrouds came in yesterday, And i'm getting
ready to do this job. I've got the cis injector tool for a little bit of
help pulling what I think are my original injectors. I'm looking for a
little bit of procedures/guidance and maybe some encouragement for not
dropping the shoruds into my head.

Whatdya say?

-Dave
_______________________________________________
quattro mailing list
quattro at audifans.com
http://www.audifans.com/mailman/listinfo/quattro
---
Watch this space for ads :)