Transmission questions

[urq]

... the V8 tranny has a pump for the cooler ... I think they also command a
bit of a premium due to their rarity ... 

What about a tranny from an urS4?

Steve B
San Jose, CA (USA)

-----Original Message-----

Brett,

Assuming I install the trans on a 200Q with engine that will deal with
torque, will it
work OK - bolt up using 200 flywheel and clutch and work OK with final drive
to rear
diff?  I don't think gear ratio would be a problem unless the first gear
were especially
high.  I was looking to mate the trans with a more powerful I5 engine -
although it
would not be as torquey as the V8 to be sure.

Ben

-----Original Message-----

On Wed, Apr 22, 2009 at 1:50 PM, Ben Swann <benswann at verizon.net> wrote:

> I have a 200Q20V with broken input shaft - amazing and never saw this
happen before.

Yikes.  That is...unusual.

> Is V8 quattro transmission a bolt-in with same ratios?

The 5-speed?  No, the gearing is different for the torque-y V8.
You're far more likely to find a 200q20v transmission, regardless.

Brett