UrS4 brake hose swap and fluid flush

[phixxitt at yahoo.com]

I am not familiar with you particular car but, If you are not reusing the hose you can cut above the fitting off and use a six point deepwell socket in most cases. (Along with some PB blaster)



------Original Message------
From: Mark Rosenkrantz
Sender: quattro-bounces at audifans.com
To: theringmeister at triad.rr.com
Cc: quattro at audifans.com
Cc: s-car-list at audifans.com
Subject: Re: UrS4 brake hose swap and fluid flush
Sent: Jun 22, 2009 12:42 PM

Penetrating lubricant and vice grips.  Works almost every time!  =)

Seriously, this is what I have to use on old lines.  With normal flares and
other specialty tools, the fittings still get rounded.

Mark Rosenkrantz



On Mon, Jun 22, 2009 at 11:43 AM, Wylie Bean <theringmeister at triad.rr.com>wrote:

> Planning to swap all 4 rubber brake hoses for new rubber hoses and was
> going to flush fluid at the same time.  I am trying to get the rear hose off
> at the hard line and don't seem to be making any progress.
> Tips?  Suggestions?  I am without a torch to heat the connection...
> Wylie Bean
> TheRingmeister at triad.rr.com
> 90 cq
> 91 90q20v
> 92 UrS4
> 08 Q7 3.6
> Sent on the Sprint® Now Network from my BlackBerry®
>_______________________________________________
> quattro mailing list
> http://www.audifans.com/mailman/listinfo/quattro
> http://www.audifans.com/kb/List_information
>
_______________________________________________
quattro mailing list
http://www.audifans.com/mailman/listinfo/quattro
http://www.audifans.com/kb/List_information


Sent via BlackBerry by AT&T