Big Brakes on a Ur-Q?

Big Brake Parts bigbrakeparts at gmail.com
Sat May 2 19:00:27 PDT 2009


What S8 rotor are talking about? 323x30? If yes then try 2000 S4 8D0  
615 301M rotor. The overall height is much less then A8 4D0 615 301M  
part. I have both in my garage and can measure if needed.

Just wondering why you need big brakes? Use the car on the track?

Eugene.

May 2, 2009, в 7:39, "Andrew Dickinson" <amdickinson at rogers.com>  
написал(а):

> Hi all:
>
> I have managed to pull together all the parts I thought I required  
> for a
> big Brembo set up.  Unfortunately the S8 rotors aren't even close to
> fitting.  I have the RS2 carrier/caliper adapter brackets and a set of
> 996 Brembos calipers with the right adaptive SS Lines.
>
> Does anyone have any thoughts as to another 5x112 bolt pattern rotor
> that I can use?  The S8 hat stands proud by a centimeter or more I  
> would
> guess.  It rubs against the lower strut housing/hub assy.
>
> Failing that is it possible to cut and weld the lower assy to clear  
> the
> large S8 rotor?  I think this wil still result tin the rotor sitting  
> too
> far back afterwards.
>
> Then there is the possibility of wheel spacers... But behind the  
> rotor.
>
> Does anyone have any thoughts on this?
>
> I contacted 034 and their only suggestion was an A8 hat but I suspect
> the rotor/hub offset issue will be the same.
>
> Any ideas or suggestions are appreciated.
>
> Cheers;
>
> Andrew
>
> _______________________________________________
> quattro mailing list
> http://www.audifans.com/mailman/listinfo/quattro
> http://www.audifans.com/kb/List_information


More information about the quattro mailing list