brakes on '02 a4tavant
Dan DiBiase
d_dibiase at yahoo.com
Sat Jul 31 05:39:29 PDT 2010
So how difficult a job is it to do this - replace brake pads and rotors? Any
special tools needed? Do you need to
bleed the brakes when complete?
Dan D
'04 A4 1.8Tq MT-6
Central NJ USA
________________________________
From: Mark Rosenkrantz <speedracer.mark at gmail.com>
To: hayes myers <hayesmyers at gmail.com>
Cc: quattro at audifans.com
Sent: Fri, July 30, 2010 5:43:09 PM
Subject: Re: brakes on '02 a4tavant
Non-sport 1.8... Hayes is right. And as a Stoptech dealer, I put them on
both my 2.7T S4 and Corvette Z06. Rockin stuff!
Mark Rosenkrantz
On Fri, Jul 30, 2010 at 4:29 PM, hayes myers <hayesmyers at gmail.com> wrote:
> 288
> On Fri, Jul 30, 2010 at 4:27 PM, Steve Meyer <quattroslm at yahoo.com>
> wrote:
>
> > I need new front pads and rotors on my A4 and need to figure out what
> size
> > brakes I have. Did they use different sizes on the same model? I have a
> > non-sport 2002 1.8tq avant. The part sites are showing 288mm or 312mm. I
> > haven't had time to actually pull the wheel off and try to measure, I was
> > hoping it was dependent upon my model. Thanks!
> >
> > Steve
> >
> >
> >
> > _______________________________________________
> > quattro mailing list
> > http://www.audifans.com/mailman/listinfo/quattro
> > http://www.audifans.com/kb/List_information
> >
> _______________________________________________
> quattro mailing list
> http://www.audifans.com/mailman/listinfo/quattro
> http://www.audifans.com/kb/List_information
>
_______________________________________________
quattro mailing list
http://www.audifans.com/mailman/listinfo/quattro
http://www.audifans.com/kb/List_information
More information about the quattro
mailing list