[s-cars] 3B engine replacement options for "Deerslayer"Frankenmotor

[Bares, Vittorio]

I agree w/Nick check out MG - don't know very much about mixing w/a 2.6
stroker bottom.

I know that the MC2 will give about 6.7:1 compression or so, one guy
made this work but was running 36lbs of boost.

MC1 is a little bit better, but still relatively low compression.

Vittorio -
-----Original Message-----
From: s-car-list-bounces at audifans.com
[mailto:s-car-list-bounces at audifans.com] On Behalf Of NIck Miller
Sent: Sunday, September 05, 2010 5:06 PM
To: Ben Swann
Cc: s-car-list at audifans.com; quattro at audifans.com; 200q20V mailing list
Subject: Re: [s-cars] 3B engine replacement options for
"Deerslayer"Frankenmotor

Hey been, you should probably drop this by the guys at motorgeek.  I
don't
believe the domed pistons from the 10v block will work out with the 3b
head,
I haven't done any looking for a long while but I believe that the deck
height and the way the combustion chambers are done you need very
different
pistons between a 20v block (3b or AAN) and a 10v.

You may check out a thread "20v on the cheap" at motorgeek, some guy
figured
out the needed parts to use an MC block and 7a head, then turbo'd it.
using
pistons from something else as well.

Either way, can't you just measure the distance from the deck to the top
of
one of the pistons, and then figure out if that will work with the head?
Such as you have a blown 3b, so if the distance from the deck to the
piston
is similar, then it should be within the realm of possiblity, no?
_______________________________________________
S-CAR-List mailing list
http://audifans.com/mailman/listinfo/s-car-list
http://www.audifans.com/kb/List_information