UrS4 list and bouncy speedo

[Hayes Myers]

I resoldered all connections on my board and my clock came back to life and
my speedo bounce was gone. this was an Audi200 however.

On Mon, Sep 13, 2010 at 5:00 PM, rob <rob3 at hod3.fsnet.co.uk> wrote:

>
>  Hi,
>
>   Just wondered if you could expand on that? Do you mean the circuit board
> that is housed in the piggyback, swing down unit ? I've had a look at it and
> it all seems fine, no obvious dry joint or anything. Is there something to
> look for?
>
>     Thanks Rob.
>
>
> ----- Original Message -----
> *From:* Hayes Myers <hayesmyers at gmail.com>
> *To:* audi at humanspeakers.com
> *Cc:* rob <rob3 at hod3.fsnet.co.uk> ; quattro at audifans.com
> *Sent:* Saturday, September 11, 2010 9:35 PM
> *Subject:* Re: UrS4 list and bouncy speedo
>
> fix your i/c circuitboard and all else will be fixed.. ie; the clock, the
> bounce etc
>
> On Sat, Sep 11, 2010 at 2:05 PM, Huw Powell <audi at humanspeakers.com>wrote:
>
>>
>> > When in bouncy needle mode the cruise will not latch on. According to
>> > Huw's site one of the pins on the speedo is a cruise output
>>
>> It's the other way around - the cruise reads the speedometer position
>> with a little coil or something.
>>
>> It makes sense that cruise wouldn't work if it couldn't read the speedo
>> properly, or "control" it via the vacuum pump.
>>
>> --
>> Huw Powell
>>
>> http://www.humanspeakers.com/audi
>>
>> http://www.humanthoughts.org/
>>  _______________________________________________
>> quattro mailing list
>> http://www.audifans.com/mailman/listinfo/quattro
>> http://www.audifans.com/kb/List_information
>>
>
>
>
>