High Pressure Hydraulic Hose
Max Hoepli
mhoepli at vif.com
Wed Sep 29 18:10:09 PDT 2010
I used 2 clamps on the end of the hose at the pump....It didn't work...The
hose came off.
I ordered a hose from an online auto parts supplier.
Max
-----Original Message-----
From: Huw Powell [mailto:audi at humanspeakers.com]
Sent: Saturday, September 25, 2010 23:22
To: Max Hoepli
Cc: audi_owners_usa at yahoogroups.com; quattro at audifans.com;
w-t_audifans at yahoogroups.com
Subject: Re: High Pressure Hydraulic Hose
Somehow I doubt a single hose clamp is going to be sufficient to replace
what was a very high pressure swaged fitting. Be careful.
On 9/25/2010 10:20 PM, Max Hoepli wrote:
> Hi all,
>
>
>
> I just changed my low pressure hose, the hose from reservoir to pump using
a
> "Dayco Abrasion King PUSH-ON 710-50 /8<15.5> 3000PSI MAX WP MSHA
IC-123/10
> MADE IN USA 010808C". I just arrived home after having driven 170km and
the
> end of the high pressure hose that pumps to the rack at the pump end came
> off. Oil squirted onto driveway. It is a banjo fitting to pump. The hose
is
> around a 8mm inner metal tube; and around the hose end a 20mm outer metal
> tube. I cut off the 20mm end and am going to use a hose clamp around the
> hose and inner tube. I think if I use a 6mm wide hose clamp to bind end of
> hose to banjo ending should suffice. The hose looks in good shape.
>
>
>
>
>
> Patient: 1986 type 44 Turbo Quattro, 310,000km
>
>
>
>
>
> Max
>
> _______________________________________________
> quattro mailing list
> http://www.audifans.com/mailman/listinfo/quattro
> http://www.audifans.com/kb/List_information
>
--
Huw Powell
http://www.humanspeakers.com/audi
http://www.humanthoughts.org/
More information about the quattro
mailing list