Rear locking differential 1988 90Q

[Tony Hoffman]

This is correct. I've done plenty, I generally use either OEM trans mounts
or 034's trans mounts.

Check the trans mounts while you are in there, they are usually toast. Time
for four new mounts ;-)


Tony

On Wed, Aug 8, 2012 at 11:34 PM, Louis-Alain Richard <laraa at sympatico.ca>wrote:

> Radek, here is a long shot.
> I "think" the front transmission mounts are identical size-wise. But the
> rubber hardness or strength is different.
>
> So, for 5$ or 15$ each (brand dependent), you may try # 431 399 151D from
> a place like this :
>
>
> http://www.ecstuning.com/Audi-200-Quattro-10v_T/Drivetrain/Mounts/ES1873506/
>
> http://www.ecstuning.com/Audi-200-Quattro-10v_T/Drivetrain/Mounts/ES2091072/
>
>
> If I were you, I'd try that. If they don't fit, then install them in front
> !
>
> Louis-Alain
>
>
>
> -----Message d'origine-----
>
> Thank you guys very much for your help, without you I wouldn't be able to
> figure all this out!
>
> PS:  do you know a good (read:  cheap) source of differential mounts?
> Worldpack sources don't have it, dealer sources are pricey.
> Thanks again!
>
> Radek.
>
>
>  _______________________________________________
> quattro mailing list
> http://www.audifans.com/mailman/listinfo/quattro
> http://www.audifans.com/kb/List_information
>