Timing belt change - marks on flywheel and on vibration damper not aligning

[Tihol Tiholov]

Not necessarily. Mine (on a '88 90 q) lasted for at least 40 or 50K kms
after a t-belt job with no issues and it was not the cause for getting the
car out of service.


> From: Louis-Alain Richard <laraa at sympatico.ca>
> ..
>
> If this is the case, would such a pulley be prone to complete destruction
> in a short period of time ?
>
> Louis-Alain
>
>
> -----Message d'origine-----
>
> Then the damper pulley outer surface has shifted on the rubber, relative
> to the inner portion. Seen that too, but not as often as a
> sheared key. Either way, as mentioned by many, just use the flywheel mark
> for the crank.
>
> Tony
>
>
>
>
> ------------------------------
>
> _______________________________________________
> quattro mailing list
> quattro at audifans.com
> http://www.audifans.com/mailman/listinfo/quattro
>
>
> End of quattro Digest, Vol 110, Issue 11
> ****************************************
>



-- 
Tihol