87 5kCS tranny stuck, won't come out

[John Lagnese]

That would certainly push a bit. Possibility VERY gently floor jack push up to see if there is any movement. No more than unweighing the tranny.

Nick Lawrence <nick at beol.net> wrote:
>As long as all the bolts are out.... would anybody else think about 
>hooking the clutch release back up and stomping on the clutch pedal.... 
>well maybe gently pushing?
>On 8/5/2014 10:37 PM, patrick gillen wrote:
>> I am befuddled.  All bolts are out, 2 sets of eyes looked over many times.
>> Everything is disconnected, but trans will not budge.  I do recall there are
>> a couple of locating sleeves, but I have never seen these seize up like
>> this.
>>
>>   
>>
>> Anybody have similar issue?  Could it be the input shaft stuck to crank
>> pilot bearing? Just kidding only partially here as I can't pry bell housing
>> away from engine a fraction of a mm. I am get ready to cum-along it but thot
>> I'd ask first.
>>
>>   
>>
>> Patrick Gillen
>>
>> 503-704-9156 c
>>
>>   
>>
>> _______________________________________________
>> quattro mailing list
>> http://www.audifans.com/mailman/listinfo/quattro
>> http://www.audifans.com/kb/List_information
>
>_______________________________________________
>quattro mailing list
>http://www.audifans.com/mailman/listinfo/quattro
>http://www.audifans.com/kb/List_information