Changing Belts

[JohnLagnese]

Pushing the car while in gear is how I turn the belt on with the motor turn.

-----Original Message-----
From: quattro [mailto:quattro-bounces at audifans.com]On Behalf Of DeWitt
Harrison
Sent: Sunday, August 17, 2014 6:37 PM
To: mboucher70 at hotmail.com
Cc: Quattro List
Subject: Re: Changing Belts


On Thu, 14 Aug 2014 23:57:47 -0400
"mboucher70 hotmail.com" <mboucher70 at hotmail.com> wrote:

> [ ... ]
> What’s the trick to getting a belt onto and off of the air-conditioner
compressor?  Car is 1990
> Audi 100, NF, Non-Turbo, Non-Quattro
>
> I recently set out to change all three belts, and for the ac belt, the
correct one was listed as
> 13x915.
>
> With both the hydraulic pump, and the alternator, I was able to loosen
them enough that the
> belts easily slipped on and off.
>
> With the A/C, it was a different story.  The compressor adjusting bolts
were loosened and the
> compressor moved as close to the crankshaft pulley as possible.  It
simply couldn’t move any > closer as it was up against the oil pan.
>
> [ ... ]

You used the correct belt. The OEM belt, 034 260 849, is described as size
12.5 x 912 La
and if you buy non-OEM you will probably be steered to something like a
Continental
CONTITECH 13 x 915. The extra 3 mm may be because the belt is 0.5 mm wider
than OEM.

Either option is tight. I "roll" it on. That is, I put the belt around the
crank pulley and get it
started onto the AC compressor pulley. Then, while holding it in position
with one hand, I turn
the crank pulley with a ratchet on the crank pulley bolt. It rolls right on
with no damage
and, when the belt is tensioned, the adjustment falls about in mid-range.
Roll it off in a
similar manner using some sort of flat bar to force the belt out of the AC
compressor pulley
groove as the pulley is rotated.

DeWitt Harrison
'88 5ktq
_______________________________________________
quattro mailing list
http://www.audifans.com/mailman/listinfo/quattro
http://www.audifans.com/kb/List_information