[s-cars] MTM chip wastegate adjustment
Walsh, Edward
edward.walsh at agedwards.com
Wed Aug 14 11:55:40 EDT 2002
Bob, Rich
Here is an easier way to get the protective cap off the WG adjustment port.
-Drill 1/8" hole in center of cap - or tap a hole using a hammer and sharp
awl
-Screw a machine or wood screw about a 1/4 inch into the hole. (there is
apprx. 3/8 inch of clearance from cap to hex head of adj. screw)
-Grab screw with pliers and pry off in a lateral motion
The cap will come clean off and leave a nice round hole.
This is performed most easily in situ. There is no need to take the upper
WG off. (unless you enjoy hunting for up to 8 miniscule fallen under your
car!)
--------------------------------------------------------------------------
Notice: Since e-mail messages sent between you and A.G. Edwards &
Sons, Inc. ("AGE") and its employees are transmitted over the
Internet, AGE cannot assure that such messages are secure. You
should be careful in transmitting information to AGE that you
consider confidential. If you are uncomfortable with such risks,
you may decide not to use e-mail to communicate with AGE. Although
you may be sending an e-mail message to a specific AGE employee,
other AGE employees may review such messages. Additionally, your
e-mail messages to AGE may, consistent with AGE's regulatory
requirements and retention policies, be retained. You should also
be aware that e-mail messages may be delayed or undelivered. AGE
does not accept orders to effect transactions or other similar
instructions through e-mail messages.
---------------------------------------------------------------------------
More information about the S-car-list
mailing list