[s-cars] MTM chip wastegate adjustment

[Cody Payne]

Agree...my cap was nearly resting on the top of the hex screw...however I was still able to use the below technique; I drilled dead center of the cap and when I screwed the screw in...it just went down in to the hole and in the hole of the hex screw...then I just tweaked the screw and pop..it comes right off.

cp

-----Original Message-----
From: bob.rossato at att.net [mailto:bob.rossato at att.net]
Sent: Wednesday, August 14, 2002 9:50 AM
To: Walsh, Edward
Cc: 's-car-list at audifans.com'
Subject: RE: [s-cars] MTM chip wastegate adjustment



> -Screw a machine or wood screw about a 1/4 inch into the hole.  (there is
> apprx. 3/8 inch of clearance from cap to hex head of adj. screw)
>

This was most definitely not the case with the cap on Paul's wastegate. When the drill broke through the disc you could not see a separation line between the disc and the adj. screw.  They were that close.  I'm sure the disc deflected down somewhat but not that much.  Sounds like this will vary from unit to unit.

Bob
_______________________________________________
S-CAR-List mailing list
S-CAR-List at audifans.com
http://www.audifans.com/mailman/listinfo/s-car-list